Craftsman 315.21636 owner manual Flatbladescrewdriver, Small Combination Square

Page 8

_lj WARNING: To prevent accidental starting or electrical shock that could cause possible

serious personal injury, assemble all parts to your saw before connecting it to power supply. Saw should never be connected to power supply when you are assembling parts, making adjustments, lubricating, installing or removing. blades, cleaning, or when not in use.

Carefully lift saw from the carton and place it on a level work surface.

Remove pack of 2 extra blades and owner's manual from the carton.

_, WARNING: If any parts are missing, do not operate this tool until the missing parts are

replaced. Failure to do so could result in possible serious personal injury.

•Do not discard the packing materials until you have carefully inspected the saw, identified all parts, and satisfactorily operated your new saw.

Note: If any parts are damaged or missing, do not attempt to plug in the power cord and turn the switch on until the damaged or missing parts are obtained and are installed correctly.

Your scroll saw comes completely assembled. A package of 2 extra blades and an owner's manual are included with your saw.

The following tools (not included) are needed for adjustments and alignment:

•Small Combination Square

•Adjustable wrench

•Flatblade Screwdriver

SMALL

COMBINATION

SQUARE

FLATBLADESCREWDRIVER

Fig. 2

Image 8

Contents OwnersManual Save this manual for future referenceAssembly AdjustmentsMaintenance Troubleshooting ExplodedViewandRepairPartsListRead ALL Instructions Symbol Meaning Safety Alert SymbolRemove Adjusting Keys Always Wear Safety Glasses with Rules for Safe OperationBlade or cutter only Sure all guards are operating properly before each useUnattended while connected to a power source Before Making a CUT, be Sure ALL Adjustments are SecureDamage Do not Feed the Material TOO QuicklyLength of Extension Cord Wire Size A.W.G Up to 25 feetElectrical Connection Grounding InstructionsLeading End Nonferrous MetalResin SPMFlatbladescrewdriver Small Combination SquareCrrftsmrn Tensionquickrelease Adjustingknob Knob Lock OFF PostToolless Blade Holders Blade Storage DrawerHold Down FOOT/BLADE Guard Sawdust BlowerSawdust Exhaust Mounting Scroll SAW to WorkbenchTurn off the saw and unplug before making any adjustments Clamp Mounting Board Clamf WorkbenchClamping Scroll SAW to Workbench AIR Diaphragm Hold Down Foot BladeTablelock Knob Setting the Table for Horizontal or Bevel CuttingHolddownrod Holddownfoot Foot Bladeguard Erodegre Stopassembly Before installing, removing, or replacing the bladeInstalling Blades HEX Bolt SAW Table HEX NUTPlainend Bladeknob Sawdust Exhaust Adjusting Blade Tension Turn off and unplug the sawGeneral Operation Lock PostON/OFFKNOB = Interior Scroll Cutting Drillhole Interior CUTBefore Each USE Stack CuttingChoice of Blade and Speed Turn switch OFF General MaintenanceBefore Freeing ANY Jammed Material ARM BearingsProblem Cause SolutionPage Craftsman Scroll SAW- Model no Figure aCraftsman Scroll SAW Model no Key Part No. NumberDescription Quan BladeFigure B Description Available From Division 98 SourceKey Pad No. Number Standard Hardware Item --May Be Purchased LocallyParts Direct s