Craftsman 119.214 owner manual NutforcorrectingtheworkingtableflatnessSeeFig

b.Fastentheguiderailwithtwoeachstarknobscrewandwasher

tothetableUsethehexsocketheadcapscrew,washerandwing.

nutforcorrectingtheworkingtableflatness(SeeFig. .2)

FIG. 2

d.Placethebladetensionknobontothebladetensioner(See Fig.4).

FIG, 4

e. To ensure sufficient upright stability of the machine it should be bolted to floor, bench or worktable. For this purpose 6mm holes are provided in the machine's base. (See Fig. 5)

c. Lay the rip fence onto the guide rail. Adjust the rip fence parallel to the saw blade. Tighten rip fence handle by pressing downward. (See Fig. 3)

FIG. 5

f. The bandsaw has a 2-1/2" dust port included. (Sea Fig. 6)

It is recommended that when in use, the bandsaw is connected to a suitable dust collector.

!"

FIG. 6

tension knob
=g knob	T

_Blade	rack ng knob
]uide	'Guidepost adjusting knob
_. _	,

Look

Lower tabl

Dust