GZ50N
4. Fuel
■FUEL
•Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the en- gine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 3 m (10 ft) away from the fueling point before starting the engine.
•The Zenoah engines are lubricated by oil specially formu- lated for
•Do not use BIA or TCW
■MIXING RATIO GASOLINE 50 : OIL 1
•Exhaust emission are controlled by the fundamental en- gine parameters and components (eq., carburation, igni- tion timing and port timing) without addition of any ma- jor hardware or the introduction of an inert material dur- ing combustion.
•These engines are certified to operate on unleaded gaso- line.
•Make sure to use gasoline with a minimum octane number of 89RON (USA/Canada: 87AL).
•If you use a gasoline of a lower octane value than prescribed, there is a danger that the engine temperature may rise and an engine problem such as piston seizing may consequently occur.
•Unleaded gasoline is recommended to reduce the contami- nation of the air for the sake of your health and the environ- ment.
•Poor quality gasolines or oils may damage sealing rings, fuel lines or fuel tank of the engine.
4.Pour in the rest of gasoline and agitate again for at least one minute. As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary for the engine to last long. Be careful that, if the agitation is insuffi- cient, there is an increased danger of early piston seizing due to abnormally lean mixture.
5.Put a clear indication on the outside of the container to avoid mixing up with gasoline or other containers.
6.Indicate the contents on outside of container for easy identi- fication.
■FUELING THE UNIT
1.Untwist and remove the fuel cap. Rest the cap on a dustless place.
2.Put fuel into the fuel tank to 80% of the full capacity.
3.Fasten the fuel cap securely and wipe up any fuel spillage around the unit.
1.Select bare ground for fueling.
2.Move at least 10 feet (3 meters) away from the fueling point before starting the engine.
3.Stop the engine before refueling the unit. At that time, be sure to sufficiently agitate the mixed gasoline in the container.
■FOR YOUR ENGINE LIFE, AVOID:
1.FUEL WITH NO OIL (RAW GASOLINE) – It will cause severe damage to the internal engine parts very quickly.
2.GASOHOL – It can cause deterioration of rubber and/or plas- tic parts and disruption of engine lubrication.
3.OIL FOR
4.Mixed fuels which have been left unused for a period of one month or more may clog the carburetor and result in the engine failing to operate properly.
5.In the case of storing the product for a long period of time, clean the fuel tank after rendering it empty. Next, activate the engine and empty the carburetor of the composite fuel.
6.In the case of scrapping the used mixed oil container, scrap it only at an authorized repository site.
•As for details of quality assurance, read the description in the section Limited Warranty carefully. Moreover, normal wear and change in product with no functional influence are not covered by the warranty. Also, be careful that, if the usage in the instruction manual is not observed as to the mixed gaso- line, etc. described therein, it may not be covered by the warranty.
■HOW TO MIX FUEL
• Pay attention to agitation.
1.Measure out the quantities of gasoline and oil to be mixed.
2.Put some of the gasoline into a clean, approved fuel con- tainer.
3.Pour in all of the oil and agitate well.