TROUBLE SHOOTING
| Problem |
| Possible Cause |
| Solution |
English |
|
|
|
| |
Saw will not start | 1. | Saw is not plugged in | 1. Plug to power source | ||
| fence is not straight | 2. Replace fuse or reset circuit break. | |||
|
| 2. | Fuse blown or circuit breaker | ||
|
| 3. cord is damaged | 3. Have power cord replaced by Authorized | ||
|
| 4. | Debris in ON/OFF switch | 4. Clean any debris accumulated | |
| Does not make accurate 45° | 1. Positive stop not adjusted | 1. Check the blade with square and adjust | ||
|
| 2. Blade angle pointer not set | 2. Check blade with square and adjust the | ||
|
| accurately | Blade angle pointer | ||
|
|
|
| ||
| Material Pinched Blade when | 1. Rip fence not aligned with blade | 1. Check and adjust the rip fence | ||
|
| 2. Warped wood, edge against | 2. Select another piece of wood | ||
|
|
|
| ||
| Material Binds on Splitter | 1. Splitter not in line correctly with | 1. Check and align the splitter with blade | ||
|
| blade |
|
| |
|
|
|
|
| |
| Saw makes unsatisfactory | 1. Dull Blade | 1. | Replace blade | |
|
| 2. Blade mounted backward | 2. | Turn blade around | |
|
| 3. Gum or resin on blade | 3. | Remove blade and clean | |
|
| 4. Incorrect blade for work | 4. | Change to correct blade | |
|
|
|
|
| |
| Material Kicked Back from the | 1. Rip fence out of adjustment | 1. | Align rip fence with miter gauge groove. | |
|
| 2. Splitter not in line with blade | 2. | Align splitter with blade | |
|
| 3. Feeding stock without rip fence | 3. | Install and use rip fence | |
|
| 4. Dull blade | 4. | Replace blade | |
|
| 5. Bevel Knob is not tight | 5. | Tighten the knob | |
|
|
|
| ||
| Blade does not raise or tilt | 1 Sawdust and dirt in | 1. Brush or blow out loose dust and dirt | ||
| freely | elevation/tilting mechanisms |
|
| |
|
|
|
|
|
|
| Blade does not come up to | 1. | Extension cord is too light or too | 1. | Replace extension cord to adequate size |
|
| 2. | Low house voltage | 2. | Contact electrician |
|
|
|
|
| |
| Saw vibrates excessively | 1. | Saw not mounted securely to | 1. Tighten all mounting hardware | |
|
| 2. | Bench or stand on uneven floor | 2. | |
|
| 3. | Damaged saw blade | 3. Replace blade | |
|
|
|
|
|
|
TWO-YEAR WARRANTY:
This product is warranted free from defects in material and workmanship for 2 years after date of purchase. This limited warranty does not cover normal wear and tear or damage from neglect or accident. The original purchaser is covered by this warranty and it is not transferable. Please return the tool to store location of purchase along with your receipt, and you will receive a new drill or a refund. THIS PRODUCT IS NOT WARRANTED IF USED FOR INDUSTRIAL OR COMMERCIAL PURPOSES.
TOLL-FREE HELP LINE:
For questions about this or any other GENESIS Product, please call
Or visit our website: www.richpowerinc.com
10" Table Saw |
|
Operator’s Manual | GTS10S |