Kuhn Rikon 30-100 owner manual Adjustments

Page 10

Adjustments

9.Changing Spindle Speed: The 30-100 Bench

Drill Press has five spindle speeds. To change, lift the cover with the handle (A-Fig.09).

10.Loosen the motor lock knob (A-Fig.10). Move the motor (B-Fig.10) manually toward the feed handle to take tension off of the belt.

11.Move the drive belt to the desired speed position, refer to speed chart inside belt cover. Manually move the motor away from the feed handle until the belt is tensioned, tighten motor lock knob. The belt is properly tensioned when the deflection distance is 1/2” when pushed by hand (Fig.11).

A

Fig.09

AB

Fig.10

Fig.11

10

Image 10
Contents Bench Drill Press Safety Warnings Refer to them often Table of Contents SpecificationsContents of Package Getting to Know Your Drill Press Assembly Unpacking and Clean-upAssembly Adjustments Adjustments Troubleshooting Wiring Diagram Electrical Requirements Explosion Diagram Parts List DescriptionPage Page Explosion Diagram Screw-Pan M5x0.8-20 Explosion Diagram 30-100-6D Screw-Hex Hd /2-12x7/8 30-100-7D Warranty Year Limited WarrantyPage For more information