Kuhn Rikon 30-100 owner manual Assembly, Unpacking and Clean-up

Page 7

Assembly

The machine must not be plugged in and the power switch must be in the OFF position until assembly is complete.

Tools Required for Assembly

Item Description

Phillips Screwdriver

Adjustable or 13mm Wrench

Unpacking and Clean-up

1.Carefully finish removing all contents from shipping carton. Compare contents of the shipping carton with the list shown on page 5. Place parts on a protected surface.

2.Report any shipping damage to your local distributor. If parts are missing contact RIKON customer service at 877-884-5167 or techsupport@rikontools.com.

3.Clean all rust protected surfaces. Do not use; gasoline, paint thinner, mineral spirits, etc. These may damage painted surfaces.

4.Set packing material and shipping carton to the side. Do not discard until machine has been set up and is running properly.

1.Install the column to the base using the three column mounting bolts. (Fig.01)

Fig.01

2.Next install the table lock handle through the unthreaded hole on the left of the table support casting. The handle should engage the thread on the right side of the table support casting. (Fig.02)

Fig.02

7

Image 7
Contents Bench Drill Press Safety Warnings Refer to them often Specifications Table of ContentsContents of Package Getting to Know Your Drill Press Unpacking and Clean-up AssemblyAssembly Adjustments Adjustments Troubleshooting Wiring Diagram Electrical Requirements Explosion Diagram Description Parts ListPage Page Explosion Diagram Screw-Pan M5x0.8-20 Explosion Diagram 30-100-6D Screw-Hex Hd /2-12x7/8 30-100-7D Year Limited Warranty WarrantyPage For more information