Inspection and Maintenance

Reversing cutting head for ﬂush cutting operations(cont.)

6mm Socket-

Head Bolts

Figure 19

5.Making sure that the drive belt is fully engaged in the drive pulleys, slide the belt cover on and install the two socket-head bolts into the left-hand side of the mounting sur- face only until the bolts bottom on the belt cover. See Figure 19.

Figure 20

6.Adjust the tension screw until the tension indicator is in the middle of the scale. See Figure 20.

7.Tighten the two mounting bolts securely.

8.Reconnect the main water line, adjust and retighten water nozzles (if equipped with a water kit).

9. Reinstall the cutting wheel.

MAINTENANCE, REPLACEMENT, OR REPAIR OF EMISSION CONTROL DE- VICES AND SYSTEM MAY BE PERFORMED BY ANY REPAIR ESTABLISHMENT OR INDIVIDUAL. HOWEVER, WARRANTY REPAIRS MUST BE PERFORMED BY A DEALER OR SERVICE CENTER AUTHORIZED BY SHIN-DAIWA KOGYO, LTD. AND USE OF PARTS THAT ARE NOT EQUIVALENT IN PERFORMANCE AND DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE EFFECTIVENESS OF THE EMISSION CONTROL SYSTEM AND MAY HAVE A BEARING ON THE OUTCOME OF THE WARRANTY CLAIM.

Inspection and Maintenance Requirements

Item	What to Do	Daily	Weekly	Monthly	As Req’d
Air Cleaner	Clean	
Cut-off Wheel	Check & Sharpen	
Bolts/Screws	Check & Retighten	
Fuel Cap	Check Leakage	
Fuel Tank	Check Leakage	
Wheel Guard	Check Function	
Clutch Bearing	Grease		
Belt	Check and Adjust		
Spark Plug	Check and Clean			
Cylinder Fins	Clean			
Fuel Filter	Clean			
Carburetor	Adjust				
Carburetor	Adjust				