Shindaiwa 68006-94310 manual Troubleshooting, Problem

Page 24

Troubleshooting

PROBLEM

The engine does not start.

Make sure the fuel tank contains with clean, fresh fuel (pg 11).

Remove the spark plug (pg 13).

PROBLEM

Cutting performance is poor.

Make sure the choke is � pushed fully in.

Make sure the air � cleaner is clean (pg 17).

Is the spark � plug wet?

Dry the � spark plug.

Inspect the spark plug � (pg 19).

Pull the recoil starter several times to remove fuel from the cylinder.

Is the spark � plug dry?

Replace the �

fuel filter � (pg 22).

Make sure the cut-off wheel is

appropriate for your work.

Make sure the diamond � wheel is sharp.

Make sure the drive belt is � properly tightened (pg 19).

Make sure the carburetor is � is properly adjusted (pg 18).

If the above inspections and maintenance procedures do not � correct the problem, contact your Shindaiwa dealer for assistance.

24

Image 24

Contents Engine Cutoff SAW Contents Labels and SymbolsSafety Precautions Before OperationFueling the Unit Starting The EngineKickback OperationOperation Inspection and Maintenance Transport and StorageStopping The Engine Safety and Operation Information Labels EC7500EC7600Unit Description Power Transmission Technical SpeciﬁcationsAssembly Prior to AssemblyMounting the Cut-off Wheel Filling the Fuel Tank Examples of 501 mixing quantitiesStarting the Engine When the Engine is Cold Starting a Warm Engine If the Engine Doesn’t StartIf the engine still does not start OffAdjusting Wheel Guard Angle OperationWet or Dry Operation Reversing cutting head for ﬂush cutting operations Inspection and Maintenance Reversing cutting head for ﬂush cutting operationscontCleaning the Air Cleaner Adjusting the Carburetor Adjusting Idle SpeedSpark Plug Maintenance Cleaning Cylinder FinsAdjusting Belt Tension High and Low Speed NeedleReplacing the Drive Belt Checking the Cut-off WheelReplacing the Cut-off Wheel Sharpening a Diamond Cut-off Wheel Lubricating the Clutch BearingChecking the Fuel Filter Long Term Storage Troubleshooting ProblemDeclaration Conformity Declaration of ConformityPage Page Shindaiwa Inc