Tanaka 746280 owner manual Aluminum Cutting Heads Nylon Line Replacement, Fixed Line Manual Feed

PROFESSIONAL CUTTING HEADS

Aluminum Cutting Heads Nylon Line Replacement

Owner’s Manual

(#29592 - Page 2)

		FIXED LINE	MANUAL FEED
		ITEM NUMBER			ITEM NUMBER
746280			746290
1.) This head is designed to accommodate nylon			1.) This head is designed to accommodate nylon
line with a diameter of .095” - .130”. The pre-cut			line with a diameter of .095” - .105” and can hold up
lengths included in the package are 14” which will			15’ (total length). The cutting swath (determined by
provide a total cutting swath diameter of approxi-			the length of the line exiting the head from each
			side) is variable depending on the following:
mately 13”. However this length can be longer (or
				A. The diameter of line being used
shorter) depending on the following factors:
				B. The unit’s power
	A. The diameter of line being used
				C. The desired cutting speed
	B. The unit’s power
	C. The desired cutting speed		2.) Fold a pre-cut length of line with one side slightly
	D. The desired total cutting swath diameter.
			longer than the other (as shown below).
2.) Fold a pre-cut length of line in half.
			3.) On the ground facing side of the head, insert the
			two ends of the folded line in to the two holes and
3.) On the gear case facing side of the head, insert			pull them completely through (as shown below).
the two ends of the folded line in to the two holes
(just above the Tanaka logo) and pull them com-
pletely through the underside evenly.
			4.) Wind both lengths of line together in either
			direction until 8-10” remain. Insert the shortest line
			into the nearest exit hole slot then wind the
			remaining line to the slot on the opposite side. More
4.) From the opposite side of the head, feed the			line can be extended (in increments of 3”) by
lines through the holes located on the side of the			unwinding both lines to next exit hole. The total line
			length (to extend from each side) will be subject to
head and pull until they are totally extended
			the factors listed above, however a good starting
			length could be 6”.

TANAKA OFFERS OTHER HIGH QUALITY CUTTING HEADS

Fully Automatic		Semi- Automatic	Manual Feed
The Original	The BRAIN®
BRAIN®	2000

Order # 746251	Order # 746751	Order # 746451	Order # 746551
Std. Line Diameter: .095”	Std. Line Diameter: .095”	Std. Line Diameter: .095”	Std. Line Diameter: .095”
Line Capacity: 30ft. / 9.1m	Line Capacity: 20 ft./ 6.7m	Line Capacity: 25 ft. / 7.6m	Line Capacity: 25ft / 7.6 m

ISM, Inc. • 1028 4th St. SW • Auburn, WA 98001 • Phone: (253) 333-1200 • Fax: (253) 333-1212 • www.tanakapowerequipment.com