Plunge Cutting
Note: Before Plunge Cutting, drill a hole or opening for inserting the saw blade.
Never allow the tip of the saw blade to contact the workpiece.
1.Clearly mark the line of cut on the work piece.
2.From a convenient starting point within the cut out area, place the blade tip into the hole or opening. The saw should be positioned vertically at a 90° angle to the workpiece.
3.Slowly lower the Saw until the lower edge of the Guard rests on the work piece - See Figure B2.
4.Start the Saw and allow it to reach full speed.
5.With the Saw resting on the Guard, slowly lower the Saw Blade (B15/B16) onto the cut line. Continue this motion until the Saw Blade is perpendicular to the work piece.
Metal Cutting
1.When cutting metal materials with the Saw, make sure to use the metal Saw Blade (B16).
2.Lubricate the cutting surface with cut- ting oil to avoid heat
“Operating the Reciprocating Saw” section on page 17 of this manual.
Drill/Driver Set Up and Operating
Instructions
•DO NOT install the Battery Pack (1) until AFTER you complete the following steps to set up the Drill/Driver for use.
•Refer to Figure C1 for the location of the parts of the Drill/Driver for the fol- lowing steps.
Forward/Lock/Reverse |
|
Button (C10) | Clutch Cap |
Chuck Jaws
Tighten Chuck (C2)
Trigger Switch (C4)
Light Switch (C11)
LED Light (C12)
Battery Pack (1)
Figure C1
1.Center the Forward/Lock/Reverse Button (C10) to “lock” the trigger mechanism as a safety measure, so the drill does not turn on accidentally.
2.Loosen the Chuck (C2) if needed and place the desired drill bit or screw driver bit into the drill between the Chuck Jaws.
3.Tighten the Chuck until the bit is held securely in place, centered between the Chuck Jaws.
SKU 66755 | For technical questions, please call | Page 17 |