Repair
P 3/ 11
[3]DISASSEMBLY/ASSEMBLY
[3]-1. Rack Complete
DISASSEMBLING
Disassemble Rack complete as drawn in Fig. 2.
Fig. 2
1. Disassemble Holder complete | 2. Disassemble Piston complete by | 3. Pull out Rack complete. |
by turning counterclockwise. | unscrewing M3x18 Pan head screw. |
|
| M3x18 Pan head screw |
|
Holder A or B complete | Piston A, B or C complete | Rack 42 or 64 complete |
ASSEMBLING
Assemble by reversing the disassembly procedure. (Refer to Fig. 2)
[3] -2. Motor Complete, Gear Assembly
(1)Disassemble the drive section (Gear assembly, Motor complete) as drawn in Fig. 3.
Fig. 3
1.Loosen M5x16 Pan head screws, and remove Plate and Holder joint.
M5x16 Plate Pan head
screw (4 pcs.)
Holder joint A or B complete 
6.Separate drive section (Motor complete and Gear assembly) from Housing (L) complete. And disconnect receptacles from DC motor.
2.Loosen 9 pcs. of 3x16 Tapping screw, and remove Housing (R) complete.
Housing (R) complete
Gear assembly
Motor
complete
Compression spring 6 
Housing (L) complete
Receptacles
Note: Hold Compression spring 6 with your finger, or it will come off.