Makita CG140, BCG180 dimensions Assembling

Page 6

Repair

P 6/ 11

[3] DISASSEMBLY/ASSEMBLY

[3] -2. Motor Complete, Gear Assembly (cont.)

ASSEMBLING

(1)Assemble Ball bearing 6803LLU to Gear housing. Refer to the drawing on the left in Fig. 7.

(2)Mount Ball bearing 6806LLU to Spur gear 10. Refer to the drawing on the bottom in Fig. 6.

(3)Assemble the Spur gear 10 section to Gear housing. Refer to the drawing on the upper right in Fig. 6.

(4)Mount Oil seal 30 to Spacer. Refer to the drawing on the bottom in Fig. 5.

(5)Assemble Plate 23, Spacer, Internal gear 48 and Spur gear 9C complete to Gear housing as drawn in Fig. 8.

Fig. 8

Note: Assemble Spacer with the convex side of it facing to Internal gear 48.

Spacer

Oil seal 30

Gear housing

 

 

 

 

Spur gear 9C

Internal gear 48

Plate 23

complete

(6)Assemble the parts on the Flat washer 5 side to Gear housing as drawn in Fig. 9.

Fig. 9

1.Set Carrier A complete on 1R027, and assemble Carrier B and 9 pcs. of Pin 3.

Pin 3 (9 pcs.)

Carrier B

Carrier A complete

1R027

2.While holding Internal gear 48

with your fingers, assemble Gear housing to Carrier A complete section.

Gear housing

<Note for Assembling of Pin 3 > Do not lubricate on Pin 3.

And, be careful that Pin 3 easily falls off.

3.Assemble Spur gear 19B to the Pins of Carrier A complete. And then, mount Flat washer 5 to Gear housing.

4.Assemble Stop ring E-4 to the shaft on Spur gear 9C complete.

Flat washer 5

Spur gear 19B ( 3 pcs.)

Pins of Carrier A complete

Spur gear 9C complete

Stop ring E-4

Image 6
Contents Specification Optional accessoriesStandard equipment Necessary Repairing Tools RepairMotor Complete, Gear Assembly Rack CompleteDISASSEMBLY/ASSEMBLY Arbor press Assembling DISASSEMBLY/ASSEMBLY Make sure that Compression spring 6 fits inside the space Circuit diagram Fig. D-1Wiring diagram Fig. D-2 Wiring of DC motor’s Lead wiresFig. D-4 Wiring in Housing set L Viewed from Housing R side