Important Safety Information

PLEASE! DO NOT RETURN THIS PRODUCT TO ANY RETAIL STORE!

For any questions or problems with this product please contact us at:

Email: info@interactivetoy.com

Phone: Inside North America: +1-416-444-6873

Outside North America: 1-866-214-2220

Address: Interactive Toy Concepts,

17 Vulcan Street, Toronto, Ontario, Canada. M9V 1L3

Web site: www.interactivetoy.com

REPLACING THE DUCK’S MAIN WINGS.

You can replace the original wings on your Duck if they become damaged. A new set of wings can be purchased by contacting Interactive Toy Concepts as outlined in this manual. To replace the wings, do the following:

1.Make sure the Duck is not flapping its wings. In other words, shoot it down with the Infrared Blaster or allow it to expire the charge in its capacitor and finish flapping its wings.

2.Gently disconnect the rear corner of the wing that is tethered to the body by a ball joint.

3.The leading (front) edge of the wing is a thin carbon fiber rod. Gently pull this rod out of the gear box mechanism housing at the front.

4.Installation of the new wing is the reverse of the wing removal procedure with the following minor difference. The carbon fiber rod has a slight notch cut into its end so that it will only fit properly into gear box mechanism housing one way. Use caution when inserting the carbon fiber rod. If it is not going in smoothly, it is misaligned.

Do not modify your DUCK HUNTER - LAUNCH & LOAD toy. Do not use in strong winds, use only in VERY mild conditions! Do not use in rain, snow or around heavy debris! Do not use near electrical lines! Do not use around smoke or flames! Do not use around water! Do not use around electricity! Do not use in crowded areas! Do not use around air conditioning! Do not use around air vents! Do not use around ceiling fans! Do not use around large obstacles! Do not use in very small spaces! Do be conscious of changes in your area! Any changes or modifications to this product are strictly prohibited and will void product warranty. Keep moving wings away from eyes, hands, hair and loose clothing. Always turn off your Infrared Blaster when not in use. Always remove batteries from Infrared Blaster during storage. Always replace Infrared Blaster with NEW alkaline batteries for optimal performance. Keep your instruction manual in a safe place for future use. Only use the provided Infrared Blaster included with the DUCK HUNTER - LAUNCH & LOAD to charge the capacitor installed in the DUCK HUNTER - LAUNCH & LOAD.

Limited 30-day warranty

Product is warranted by Interactive Toy Concepts Limited against

manufacturing defects in material and workmanship under normal useProof of Purchase for (30) days from the date of purchase.

Warranty is validated upon receipt of proof or purchase and confirmation of UPC code.

Duck Hunter and Hunter Series are registered trademarks of Interactive Toy Concepts.

Patent Information: EU: EP1958681 US: US2008191100 Canada: CA2607358 Aus: AU2007231617

Products and colors may vary. MADE IN CHINA.

INS-44078-110305-US

10+

Item# 44078

INSTRUCTION MANUAL

Congratulations on your purchase of the DUCK HUNTER LAUNCH & LOAD

The DUCK HUNTER - LAUNCH & LOAD is a revolutionary new toy that allows anyone to have the virtual learning experience of hunting a Duck in complete safety.

The Infrared Blaster is equipped with a launch mechanism that is used to charge and launch a fully functional flying “Ornithopter” Duck into the air. An Ornithopter is a device that flies by flapping its wings. Thus, the Ornithopter Duck’s flying pattern is very life-like. The Infrared Blaster then uses a safe narrow infrared beam to shoot down the Duck. The Duck will fly for up to 30-40 seconds from a 15 second charge. The body of the Duck is made of an ultra-light and flexible foam which provides excellent structure and resistance to damage. Since the flying direction of the Duck can be preset, it is possible to play with the DUCK HUNTER - LAUNCH & LOAD toy indoors or outdoors. It takes 3 direct hits from the Infrared Blaster to bring down the Duck. It is possible to have a competitive game-play with any number of multiple players or to practice solo target shooting accuracy. A multiple player game-play consists of counting the number of shots fired to bring down the Duck. The person who fires the least amount of shots is the winner.

	DUCK HUNTER Launch
	& Load has been	1 Charger/
	carefully packaged to	Display Stand
	avoid damage during
	shipping.	1 Infra-red Shooter/
	PLEASE USE	Portable Charger
	CAUTION WHEN	UCK HUNTER”
	UNPACKING.	UCK HUNTER”
	UNPACKING.	Flying Duck

Start hunting your duck fast!

1. Turn on the Infrared Blaster! The switch is located on the bottom of the Infrared Blaster just ahead of the trigger.

2. Slide the Reload Pump all the way back and release it to arm the Duck Launching Mechanism.

3. Prepare your Duck for launching by mounting it on the blaster and sliding it into its groove.

4. Press and hold the trigger for 15 seconds to charge the Duck.

WARNING!!! Do not aim or launch the Duck in the direction of anyone or any living thing! In particular, do not aim or launch the Duck in any person’s face!! WARNING!!!

5. Aim the Infrared Blaster in the direction you would like the Duck to fly. It is best to aim the infrared blaster upwards. Press the Launch Button on the left side of the Infrared Blaster to launch the Duck. The Duck will start flapping its wings and fly away.

6. Start hunting the Duck by shooting a safe infrared beam at it every time you press the Infrared Blaster’s Trigger. You will need to reload the Infrared Blaster by sliding back and forth the Reload Pump after each shot. It takes 3 direct hits to bring the Duck down.

IMPORTANT BATTERY INFORMATION:

Do not mix old and new batteries, different types of batteries, standard carbon zinc, alkaline or rechargeable of different capacities. Rechargeable batteries are only to be charged under adult supervision. Please respect the correct polarity (-) or (+). Do not try to recharge non-rechargeable batteries. Do not throw batteries into the fire. Replace all batteries of the same type/brand at the same time. The supply terminals are not to be short-circuited. Remove exhausted batteries from the toy. Batteries should be replaced by adults. Remove batteries if the toy is not going to be played with for some time. Removable batteries are to be removed from the toy before they are charged. The packaging should be kept since it contains important information.