MAINTENANCE
Cleaning
Proper cleaning is the best way to ensure trouble free performance from your spray gun. If your gun is not thoroughly cleaned, damage and poor spraying will result. Problems caused by improper cleaning will not be covered by the warranty. Clean the spray gun immediately after each use.
To clean your spray gun:
1.Empty the cup and spray a small amount of solvent through the gun.
Note: If you are spraying on a regular basis, spraying solvents into the air may be illegal. A cabinet style spray gun cleaner may be required.
2.DISCONNECT SPRAY GUN FROM AIR!
3.Remove the cup and cup lid.
4.Disassemble the gun by unscrewing the fluid control knob then remove the spring and needle.
| Atomizing Cap |
| Fluid Tip |
| Fluid Control |
| Knob |
Cup |
|
Lid |
|
| Needle |
Cup | Spring |
Figure 14. Disassembly for cleaning.
5.Unscrew the atomizing cap and the fluid tip. The fully disassembled gun should look like Figure 14.
6.Rinse all parts thoroughly in solvent, then dry with compressed air or let air dry. Try not to expose O-rings to solvent or they may get damaged.
Note: If the small holes in the atomiz- ing cap become blocked, soak in clean solvent. If the blockage still exists, clear the blockage with a small needle, taking great care to not enlarge or damage the hole. Damage to the hole will create a disrupted spray pattern.
7.Use the cleaning brush with solvent to clean the inner orifice and other hard to reach areas on the outside of the spray gun body.
8.Wipe the gun body with a lint free shop towel to dry.
EXPLOSION HAZARD!
Chlorinated Solvents like 1,1,1- Tricloroethane and Methylene Chloride (methyl chloride) can chem- ically react with aluminum spray gun parts and explode. Read solvent label carefully to avoid using solvent with these chemicals.
NOTICE
DO NOT soak the spray gun body in solvent. Prolonged exposure to sol- vent will rapidly deteriorate the spray gun washers and seals. Ignoring this notice will void your warranty.
Model H8222 Spray Gun |