Earlex HV3900 Parts List, Safety Operating Instructions Please Read Before USE, Introduction

PARTS LIST
	Fig.1
No.Description		Part Code	No.Description		Part Code
1.	Needle and Fluid Tip Tool	V0018	7. Fluid Needle 2.0mm		V0006
2.	Air Cap Ring	V0001	8.	Lip Seal - Fluid Needle	V0007
3.	Air Cap	V0002	9.	Paint Flow Adjuster	V0011
4.	Spray Direction Plate	V0003	10. Paint Container Seal		L0682
5.	Fluid Tip 2.0mm	V0004	11. Pick-up Tube		V0012
6.	Fluid Tip O-Ring	V0005	12. Paint Container		V0014
PARTS LIST HV3500 Fig.2
No.Description		Part Code
13. Hose		L1064
14. Filter		L0290
PARTS LIST HV2900/3900 Fig.3
No.Description		Part Code
13. Hose		L0896
14. Filter		L0290

SAFETY OPERATING INSTRUCTIONS

PLEASE READ BEFORE USE

•Never under any circumstances aim the Spray Gun at another person or animal. In the event of injury occurring seek expert medical advice immediately.

•The Spray Gun must only be used with paints and solvents that have a flash point suitable for spraying. If in doubt, consult the paint or solvent manufacturer’s data.

•Always ensure there is adequate ventilation when spraying.

•NEVER spray near a naked flame, including appliance pilot light.

•NEVER smoke whilst spraying.

•NEVER allow children to operate or play with the Spray Gun.

•Always read the solvent manufacturer’s instructions before use.

•Always disconnect unit from mains supply when filling the paint container.

•Always wear a suitable protective mask when spraying. We would also recommend the use of gloves, goggles and overalls.

•After each use, thoroughly clean the Spray Gun.

•This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

•Use only genuine manufacturer replacement parts.

•Always disconnect the Spray Station from the mains supply before cleaning the appliance.

•Warning: The use of any accessory or attachment, other than those recommended in this instruction manual, may present a risk of personal injury.

•Use the Spray Gun for the job it was designed for only. Mis-use of the Spray Gun will invalidate the guarantee.

•Wear ear protection.

WARNING: The substances used with this Spray Gun (paints, solvents, etc.) may contain dangerous, harmful, explosive or corrosive materials. ALWAYS COMPLY WITH THE SAFETY INSTRUCTIONS ISSUED WITH THIS PRODUCT AND THE MATERIAL BEING USED.

INTRODUCTION

The concept

A motor feeds out a high volume of air (HV) and enables products to be sprayed at a low pressure (LP). The Hose feeds the air produced by the motor to the Spray Gun. The solution is released from the Fluid Tip of the Spray Gun at a very low pressure and is enclosed in a high volume of air.

The powerful motor can spray a wide range of solutions with or without dilution. However, there will always be some which will not be suitable for the Spray Gun. Good quality paint contains a high percentage of solids which make the dilution easier. The users must keep in mind that low temperatures make the paint thicker, that’s why we recommend spraying with the Spray Gun at a 15°C minimum temperature.

3