Hitachi 232624 dimensions Pinion Assembly/Rotor/Shaft/Clutch/Pulley

Pinion Assembly/Rotor/Shaft/Clutch/Pulley

Removal

If pinion assembly (8) is not removed from clutch housing (3), do 1. through 4. Otherwise, do 1 and then start at 5.

1.

Relieve pressure; page 4.

2.Disconnect field cable (X) from pressure control.

X

Fig. 5 Bottom View 8739A

3.Fig. 6. Remove five screws (5) and lockwashers

(6) and pinion assembly (8).

5

6

8

5

Fig. 6	6
	8740A

4.Fig. 7. Place pinion assembly (8) on bench with rotor side up.

5.Remove four screws (39) and lockwashers (6). Install two screws in threaded holes (E) in rotor. Alternately tighten screws until rotor comes off.

39

6

E

Fig. 7 8701A

6.Fig. 8. Remove retaining ring (Z).

7.Tap pinion shaft (A) out with plastic mallet.

Z

A

Fig. 8 8703A

8.Fig. 10. Remove drive belt shield (74) and belt (68).

9.Hold pulley (2) and remove four screws (3a) and washers (3h) from hub (3d). Remove armature (3g) and spacer (3f).

10.Remove set screw (112a) from bushing (112). Remove three bolts (112b) and three washers (112c). Use bolts to remove pulley from bushing. Remove pulley and key (1).

11.Remove three screws (27) from beneath mounting plate (D).

12.Lift off clutch housing (3).

13.Remove retaining ring (3b). Pull jack shaft assem- bly (3c) out.

308864 9