Echo MS-53BPE Disassembling and Repairing the Shut OFF Valve, Assembled shut-off valve Figure

DISASSEMBLING AND REPAIRING THE SHUT OFF VALVE

1) Assembled shut-off valve (Figure 1).

Figure 1

A

Figure 2

Valve

Stem

B

C

2)Remove the retaining pin (A) (Figure 2) place the notched end of the retaining pin on a hard surface and push down. Remove the retaining pin and slide the handle off the valve.

3)Remove the retaining nut (o-ring attached), spring, and valve stem (B) (Figure 3). Replace worn parts. Lubricate the O-rings and reassemble by reversing the steps above. Place the handle groove in the slotted area of the valve stem and make sure the locking clip is positioned in the neutral position (see “Helpful Spraying Information” section). Insert the retaining pin. Push down on the handle a few times to distribute the lubricant evenly. Check flter (C) in end of shut-off valve for debris. Remove flter and fush with water to clean out.

Figure 3

REPLACEMENT PARTS ORDER INFORMATION

569012

Flat Fan Nozzle

569010 Brass Adjustable Nozzle

569011 Poly Adjustable Nozzle

569013 Nozzle kit

10E