Echo MS-53BPE manual Wand Assembly, Installing the Pump Handle

SPRAYER COMPONENTS & USE INFORMATION, Continued

WAND ASSEMBLY

1.Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.

2.Turn and tighten the retaining nut clock-wise onto the shut-off valve.

Retaining Nut	Wand	O-ring	Shut-off
			Valve

INSTALLING THE PUMP HANDLE

The sprayer includes all hardware necessary for installing the pump handle. Install the pump handle into the base (A). Center the hole in the handle between the cut-out on the bottom of the tank base (B). Push the “C” clip over the pump handle while aligning the nub on the clip with the hole in the handle

(C). Slide washer over pump linkage (short end) (D). Slide pump arm linkage (short end) through pump handle at the bottom of the tank (D & E). Slide a second washer over the linkage and insert the cotter pin through the hole in linkage (E). Position ball over top of pump (F). The pump assembly can be rotated to orient the pump outlet into desired position (G). Rotate handle down until ball is seated in top of pump (F and G). Tighten pump retainer nut (F). Do not over tighten. Press boot over retainer nut (H). Insure pump locking nut is tight (G).

Pump Handle

A

B

C

“C” Clip

Pump Arm	D
Linkage

E

F

Boot

Retainer

Nut

Ball

Pump outlet

Pump Locking Nut

G

H

3E