Echo MS-40BP Removed with pliers and cleaned fig, Disassembling and Repairing the Shut OFF Valve

Page 10

 

8. At this point the filter cartridge in the pressure chamber base can be

 

removed with pliers and cleaned (fig 4).

 

9. The pressure chamber o-ring can also be replaced. DO NOT stretch the

 

o-ring over the bottom flange. Assemble the o-ring over the top of the

Figure 4

chamber. Apply petroleum jelly to the o-ring before reinstalling pump

 

asembly into the tank (fig. 3b).

 

10. Reassemble backwards from step 7 thru 2, performing each step in

Tank tab

reverse. Note: there is a notch/tab combination in the pump

assembly/tank to be used for alignment (fig. 5).

 

 

Pump Assembly

 

Notch

 

 

Figure 5

 

DISASSEMBLING AND REPAIRING THE SHUT OFF VALVE

Figure 1

A

Figure 2

Valve

Stem

B

C

Figure 3

1) Assembled shut-off valve (Figure 1).

2)Remove the retaining pin (A) (Figure 2) place the notched end of the retaining pin on a hard surface and push down. Remove the retaining pin and slide the handle off the valve stem.

3)Remove the retaining nut (o-ring attached), spring, and valve stem (B) (Figure 3). Replace worn parts. Lubricate the O-rings and reassemble by reversing the steps above. Place the handle groove in the slotted area of the valve stem and make sure the locking clip is positioned in the neutral position (see “Helpful Spraying Information” section). Insert the retaining pin. Push down on the handle a few times to distribute the lubricant evenly. Check filter

(C) in end of shut-off valve for debris. Remove filter and flush with water to clean out.

9E

Image 10
Contents Backpack Wash hands after handling Rules for Safe OperationApplications & USE for Your Sprayer Nozzle AssemblyWand Assembly Sprayer Components & USE InformationCotter Pin Line up holes Left Hand Slide pin through holesStage Filtering System Filling the SprayerHelpful Spraying Information CleaningPOWDER-BASED Chemicals Trouble Shooting Your Sprayer Storing / Maintaining Your SprayerDisassembling and Repairing the Piston Pump CollarDisassembling and Repairing the Pump Assembly In-tank Filter Clamp Pressure Chamber o-ringRemoved with pliers and cleaned fig Disassembling and Repairing the Shut OFF ValveReplacement Parts Order Information Nozzle AssemblyLower O-ring Upper ValvePlateUpper O-ring Piston CollarExceptions