SPRAYER COMPONENTS & USE INFORMATION, Continued
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft (A). To install the pump handle place the handle (C) over the shaft (A) aligning the pump handle hole and shaft hole. Push the straight side of the cotter pin (B) through the aligned hole as shown in figure 1 thru 3. There are holes in the pump handle to allow for either left(fig.4) or right (fig.5) hand mounting.
A
C
B
Figure 1 | Figure 2 | |
Cotter Pin | Line up holes | |
|
|
|
|
|
|
Figure 4 | Figure 5 |
Left Hand | Right Hand |
STOWAWAY PUMP HANDLE
Pull |
| Rotate |
up |
| |
| 180º | |
|
| |
|
|
|
Figure 3
Slide pin through holes.
Pump Handle Positioned For Use (right hand shown)
Set into slot
INSTALLING THE
SHOULDER STRAP
The top of the shoulder straps are attached to the tank. Attach the lower end of the straps by clipping the strap hooks to the metal frame between where the frame exits the tank and curves around.
NOTE: If your straps become contaminated with dirt or chemicals, wash with mild soap and water and let dry overnight. If this does not remove the contamination, replace with new straps.
3E
WAND CLIP
The wand can be attached to the pump handle using the wand clip.