Echo MS-40BD manual Installing the Pump Handle, Stowaway Pump Handle, Installing Shoulder Strap

SPRAYER COMPONENTS & USE INFORMATION, Continued

INSTALLING THE PUMP HANDLE
		A
The pump handle can be mounted on either side of the pump
shaft (A). To install the pump handle place the handle (C) over	C
the shaft (A) aligning the pump handle hole and shaft hole. Push		B
the straight side of the cotter pin (B) through the aligned hole as
shown in figure 1 thru 3. There are holes in the pump handle to
allow for either left(fig.4) or right (fig.5) hand mounting.

Figure 1	Figure 2
Cotter Pin	Line up holes

Figure 4	Figure 5
Left Hand	Right Hand

STOWAWAY PUMP HANDLE

Pull	Rotate
up
	180º

INSTALLING THE

SHOULDER STRAP

The top of the shoulder straps are attached to the tank. Attach the lower end of the straps by clipping the strap hooks to the metal frame between where the frame exits the tank and curves around.

3E

Figure 3

Slide pin through holes.

Pump Handle Positioned For Use (right hand shown)

Set into slot

WAND CLIP

The wand can be attached to the pump handle using the wand clip.