Motor
Reassembly
1.Tighten Belt, page 13.
2.Use petroleum jelly to grease area of shaft that makes contact with extension cable (29).
29ti9060a
3.Slide pin on motor tray (32) into slots on base and push motor and tray back into position.
32 
ti9708a
4. Replace two clevis pins (20) in base (2).
20
ti8783a
5.Reconnect all electrical wiring including ground wire (22), Wiring, page 16.
22
ti9064a
6.Pull back on motor tray (32) to create slack in extension cable (29). Loop extension cable (29) through pulley (17) and connect to extension spring (19). Apply petroleum jelly to pulley (17) and threads on knob (41).
19
17
29
ti9059a
7. Tighten knob (41).
41
ti9656a
8.To set pressure, tighten knob (41) until back of bracket (25) is approximately 1/2 in. from front of tensioning bracket.
Tighten front spacer (56) until flush to front of ten- sioning bracket (16). Tighten back spacer (56) 3/8 in. from tensioning bracket (16).
25
56
16
ti9656a
41
9. Reassemble Shroud, page 7.
11