Belt Removal and Replacement (recommended method)
Removing Belt
a.Place a ziptie around belt (19).
19
ziptie 
ti7843
Moving parts can pinch or amputate fingers and other body parts. To avoid serious injury be sure engine is in OFF position before pulling engine recoil.
b.Slowly pull ziptie toward you while at the same time slowly pulling engine recoil to rotate pul- leys. It may be necessary to reposition zip tie and repeat this procedure a few times to com- pletely remove belt from pulley.
ti7842
Hydraulic Pump Replacement
Installing Belt
a.Put belt over lower pulley (6) and align correctly.
b.Line up belt over top left side of large pulley (4).
ti7869
c.With the palm of your hand, hold the belt snug to large pulley while at the same time slowly pull engine recoil to rotate pulleys.
d.Check belt (19) alignment on both large (4) and small pulley (6). When properly positioned over pulleys, belt is centered on pulleys and com- pletely over all grooves.
ti7834
Properly Aligned | ti7837 | |
Not Aligned Properly | ||
|
NOTE: If belt is not aligned properly, to adjust belt, slowly pull engine recoil while at the same time pushing or pull- ing belt to reposition over pulley.
20 | 311283D |