Preparation
Preparation
Pressure Relief
1.Disconnect air inlet.
2.Open gun air valve (23).
ti4000b
3. Trigger gun, and spray material back into hopper.
ti3900a
Hopper Removal and Installation
The hopper (G) can be removed from the cart for clean- ing and servicing equipment.
NOTE: Before removing hopper, allow unit to cool down and/or remove compressor power pack from cart.
Hopper Removal
1.To remove hopper (G), release the latches on each side of coupler (H).
2.Lift hopper straight up, off unit.
ti3900a
Install Hopper
1.To install hopper, position coupler over material out- let and slide it straight down, over the fitting, as far as it will go.
2.Secure latches by pushing each one up and firmly into locked position.
ti3899a
6 | 313385B |