|
| Troubleshooting |
|
|
|
PROBLEM | CAUSE | SOLUTION |
|
|
|
|
|
|
Pattern too fine or too much overspray | Material too thin | Thicken material. Material must be |
|
| mixed thoroughly to a consistency that |
|
| immediately folds back in as you draw |
|
| your finger through the surface of the |
|
| material. |
|
|
|
| Air pressure at gun too high | Decrease air to gun at gun fitting and/or |
|
| regulator. |
|
|
|
| Fluid delivery too low | Increase nozzle size. |
|
|
|
|
| Increase air pressure to pump, or |
|
| decrease air to gun at gun fitting and/or |
|
| regulator. |
|
|
|
|
| Turn fluid knob out on gun. See Spray |
|
| Techniques in Operation Manual |
|
| 309915. |
|
|
|
Pattern too coarse | Material too thick | Thin material. Material must be mixed |
|
| thoroughly to a consistency that imme- |
|
| diately folds back in as you draw your |
|
| finger through the surface of the mate- |
|
| rial. |
|
|
|
| Air pressure at gun too low | Increase air to gun at gun fitting and/or |
|
| regulator. |
|
|
|
| Fluid delivery too high | Decrease nozzle size. |
|
|
|
|
| Decrease air pressure to pump, or |
|
| increase air to gun at gun fitting and/or |
|
| regulator. |
|
|
|
|
| Turn fluid knob in on gun. See Spray |
|
| Techniques in Operation Manual |
|
| 309915. |
|
|
|
313385B | 9 |