Controls

3.Install and tighten the barbed hose fitting to the air inlet with the provided nut; or attach a female 1⁄4" NPT quick connect fitting (not included) to the air inlet for connection to an air coupler.

Note: Using a 1⁄4" NPT quick discon- nect set-up, will make operation and maintenance tasks easier.

4.Attach the spray gun to an air hose regulated between 44 and 58 PSI.

Note: For the best results, use a hose that will be dedicated for spray use only. Do not use a hose that has been used with an in-line oiler or other pos- sible contaminant.

If you need additional help with this assem- bly, call our Technical Support at: (570) 546-9663.

Atomizing Cap

Cup

Fluid Control

Pattern Control

Trigger

Air Flow Control

Figure 4. Controls.

•Fluid Control: Controls the volume of material that travels through the fluid tip.

•Pattern Control: Adjusts the spray pattern from a round pattern to a wide fan.

•Atomizing Cap: Controls the spray pattern from vertical to horizontal.

•Trigger: Squeeze the trigger half way to blow air, or squeeze all the way to spray.

•Air Flow Control: Controls the fluid pressure inside the spray gun.

•Cup: Holds up to 120cc of material for spraying.

Model H8224 HVLP Spray Gun

-5-