Maintenance (continued)
Disconnect from the air source.
Warning! The Paint Cup and Spray Gun may still hold air pressure, fire the Spray Gun toward scrap material until all of the pressure is expended.
1.Remove the Paint Cup.
2.Pour residual paint into the paint container and seal it.
3.Pour
4.Secure the Paint Cup to the appropriate Gun and shake the liquid in the cup.
5.Connect to the air source and turn on the air compressor.
6.Spray the liquid onto a piece of scrap material until the spray material is free of paint.
7.Repeat if necessary.
8.After following the above procedure, use the cleaning brushes and to further clean the Spray Guns.
9.Allow the Spray Guns to dry completely before storage.
| Accessories | |
Qty. | Description | |
|
| |
1 | Extra 32 oz. Siphon Feed Paint Cup | |
|
| |
1 | Extra 8 oz. Siphon Feed Paint Cup | |
|
| |
3 | Round Bristle Brush | |
|
| |
1 | Flat Bristle Brush | |
|
| |
5 | Wooden Toothpick | |
|
| |
1 | Cleaning Needle | |
|
| |
10 | Paint Filter | |
|
| |
1 | 25’ Recoil Hose (19/64" OD; | |
NPT (IN/OUT) Mail Brass Fittings) | ||
| ||
|
| |
1 | Blow Gun | |
|
| |
4 | Nozzles | |
(Rubber, Tapered, Safety, and Needle) | ||
| ||
|
| |
1 | Male Connector | |
|
| |
1 | Female Connector | |
|
| |
1 | Female Coupler | |
|
| |
1 | Male Nipple | |
|
| |
2 | Female Nipple | |
|
| |
1 roll | Pipe Thread Seal Tape | |
|
|
SKU 93974 | For technical questions, please call | Page 13 |