Harbor Freight Tools 93305 operating instructions Air Connection

Page 6

Air Connection

For best service you should incorporate a regulator and inline filter, as shown in the diagram above. Hoses, couplers, regulators, and filters are all available at Harbor Freight Tools.

Note: Compressor pumps discharge condensed water, oil, or other contaminants along with the compressed air. Condensation causes “fish eyes” to appear in paint patterns. To avoid this problem, install water/oil removal filters and controls (not included) as close to the Spray Gun as possible. If run through the Gun, water and oil will cause damage.

1.You will need to prepare a 1/4” air connector (sold separately) to connect to the air inlet on the Spray Gun. First, wrap the 1/4” air connector (not included) with pipe thread seal tape before threading it into the Air Inlet (36). Connect the Red Air Hose (41) to the Air Outlet Connector (36). Attach the other end of the Red Air Hose (41) to the Air Inlet (80) on the Gun.

2.Set the air pressure on your compressor to 30-43 PSI. Do not exceed the maximum air pressure of 43 PSI. Also, set the air pressure on the Air Regulator to 10-30 PSI, as shown on the Gauge (38).

3.Check the air connection for leaks and then disconnect the tool from the air source.

Control Layout

Air Adjustment Knob (73)

FIGURE 1

Pattern Control Knob (57)

 

Air Cap Set (45)

Fluid Control Knob (67)

Fluid Inlet

Trigger (78)

Air Inlet (80)

SKU 93305

For technical questions, please call 1-800-444-3353;

Page 6

Troubleshooting section at end of manual.

 

 

Image 6
Contents For technical questions and replacement parts, please call 93305Contents Safety Warnings and Precautions Read all instructions before using this toolSave This Manual Page Unpacking Sprayer systemAir Connection Comparison Conventional versus Hvlp Spray Guns Fan Direction and Pattern Adjustment General tips for PreparationFan Direction Too Coarse Correct Too Fine Tighten Loosen Techniques After each use Please Read the Following Carefully SKU For technical questions, please call Problem Spray Pattern DiagnosisProblem Cause Solution Sputtering SprayLimited 1 Year warranty SKU Troubleshooting section at end of manual