IMPORTANT: Before using for the first time, the spray gun must be cleaned using a solvent based thinner. If not removed, the red oil used by the manufacturer for testing and corrosion protection may contaminate paint. IMPORTANT: The Spray Gun must be cleaned immediately after use.
Improper cleaning is a common reason for the Spray Gun not to work.
Preparation
Note: Proper paint material mixture helps to ensure less problems. Be sure to follow the manu- facturer’s directions. Most materials will spray readily if they are thinned properly.
General tips for Preparation:
1.Mix and thin the paint/materials thoroughly according to the manufacturer’s directions.
2.Carefully strain the paint/material through a paint strainer or piece of cheese cloth.
3.Remove
4.Start the air compressor.
5.To adjust the spray pattern, set up a piece of scrap material to practice on. While practicing on the scrap material, check to see that the material you are spraying has the appropriate consistency. If it appears to thin, add a very small amount of thinner (not included). BE CAREFUL when thinning. Proceed slowly, adding very minimal amounts. NEVER exceed the manufacturer’s thinning recommendations.
Fan Direction and Pattern Adjustment
Fan Direction
To change the direction of the fan from horizontal to vertical, loosen the Lock Ring and turn the Air Cap (45) 90 degrees. After the adjustment, tighten the Lock Ring by hand. See FIGURE 4 below.
Lock Ring | Horizontal Fan |
FIGURE 4 | Air |
| Cap | Vertical Fan | |
| |||||
|
|
|
|
|
|
SKU 93305 | For technical questions, please call | Page 8 | |
Troubleshooting section at end of manual. | |||
|
|