Troubleshooting

Problem	Possible Causes		Likely Solutions
Decreased output. 1. Not enough air pressure and/		1.	Check for loose connections and make sure
	or air flow.		that air supply is providing enough air flow
			(CFM) at required pressure (PSI) to the
			tool’s air inlet. Do not exceed maximum air
			pressure.
2.	Obstructed trigger.	2.	Clean around trigger to ensure free
			movement.
3.	Blocked air inlet screen (if	3.	Clean air inlet screen of buildup.
	equipped).
4.	Air leaking from loose	4.	Make sure attachments are properly
	attachment.		assembled to the housing and are tight.
		5.	Have qualified technician clean and lubricate

5.Mechanism contaminated. mechanism. Install in-line filter in air supply as stated in Initial Set Up: Air Supply.

Severe air	1.	Cross-threaded housing	1.	Check for incorrect alignment and uneven
leakage.		components.		gaps. If cross-threaded, disassemble and
(Slight air leakage				replace damaged parts before use.
is normal,	2.	Loose housing.	2.	Tighten housing assembly. If housing cannot
especially on older				be tightened properly, internal parts may be
tools.)				misaligned.
	3.	Damaged valve or housing.	3.	Replace damaged components.
	4.	Dirty, worn or damaged valve. 4. Clean or replace valve assembly.
Product not	1.	Material too thick/thin.	1.	Check material being sprayed for proper
spraying correctly.				viscosity. Ordinarily texture products should
				be the consistency of heavy cream. Wall
				Texturing products are usually a bit heavier
				than deck protecting products.
	2.	Nozzle to large/small.	2.	If product is spraying to heavily, try using a
				smaller Nozzle. Too light, change to a larger
				Nozzle.

Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect air supply before service.

PLEASE READ THE FOLLOWING CAREFULLY

The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/ or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.

SKU 66103

For technical questions, please call 1-800-444-3353.

Page 11