Harbor Freight Tools 66103 Service, Air source, Symbol Definitions, Min, Ft-lb

Page 4

e.Maintain the tool with care. Keep this tool clean. A properly maintained tool is easier to control.

f.Check for misalignment or bind- ing of moving parts, breakage of parts, and any other condition that affects the tool’s operation. If dam- aged, have the tool serviced before using. Many accidents are caused by poorly maintained tools. There is a risk of bursting if the tool is damaged.

g.Use only accessories that are identified by the manufacturer for the specific tool model. Use of an accessory not intended for use with the specific tool model, increases the risk of injury.

Service

a.Service on this Texture Paint Spray

Gun must be performed only by qualified repair personnel.

b.When servicing, use only identical, authorized replacement parts.

Air source

a.Never connect to an air source that is capable of exceeding 200 psi. Over pressurizing the tool may

cause bursting, abnormal operation, breakage of the tool or serious injury to persons. Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure range as marked on the tool. Always verify prior to using the tool that the air source has been adjusted to the rated air pressure or within the rated air-pressure range.

b.Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for the tool.

Such gases are capable of explosion and serious injury to persons.

Save these instructions.

Symbols and

Specific Safety

Instructions

Symbol Definitions

Symbol

Property or statement

no

No-load speed

.../min

minuteRevolutions or reciprocation per

PSI

Pounds per square inch of pressure

 

 

ft-lb

Foot-pounds of torque

 

 

BPM

Blows per minute

 

 

CFM

Cubic Feet per Minute flow

 

 

SCFM

Cubic Feet per Minute flow at

standard conditions

NPT

National pipe thread, tapered

 

 

NPS

National pipe thread, straight

 

 

 

WARNING marking concerning Risk

 

of Eye Injury. Wear ANSI-approved

 

eye protection.

 

WARNING marking concerning Risk

 

of Hearing Loss. Wear hearing

 

protection.

WARNING marking concerning Risk of Respiratory Injury. Wear NIOSH- approved dust mask/respirator.

Chart continued in next column.

SKU 66103

For technical questions, please call 1-800-444-3353.

Page 4

Image 4
Contents For technical questions or replacement parts, please call Distributed exclusively by Harbor Freight ToolsSafety Alert Symbol and Signal Words Save This ManualGeneral Work areaPersonal safety Tool use and careService Symbol DefinitionsAir source MinSpecific Safety Instructions Vibration PrecautionsFor technical questions, please call Initial Tool Set Up Assembly SpecificationsFunctional Description UnpackingTool Set Up Operating InstructionsWork Piece and Work Area Set Up General Operating InstructionsCleaning, Maintenance, Lubrication User-Maintenance InstructionsDo not exceed the tool’s maximum air pressure rating Problem Possible Causes Likely Solutions TroubleshootingSKU For technical questions, please call Part Description ’ty Assembly DiagramRecord Product’s Serial Number Here Limited 1 Year warranty