Operation
1/4” NPS
Sprayer
For best service you should incorporate a regulator and inline filter, as shown in the diagram above. Hoses, couplers, regulators, and filters are all available at Harbor Freight Tools.
1.You will need to prepare a 1/4” air connector (sold separately) to connect to the air inlet on the Spray Gun. First, wrap the 1/4” air connector (not included) with pipe thread seal tape before threading it into the Air Inlet (32). Connect the 3/8” ID Air Source Hose to the Spray Gun.
2.Set the air pressure on your compressor to 40 PSI. Do not exceed the maximum air pressure of 50 PSI.
3.Check the air connection for leaks and then disconnect the tool from the air source.
Vent (30)
Lid (29)
Cup (28)
Air Nozzle (1) | Fluid Control Knob (12) |
| Spray Regulator Knob (20) |
Trigger (37) |
|
Air Adjusting Valve (31) | Air Inlet (32) |
|
SKU 91009 | Page 5 |