Troubleshooting
Note: Have any of the following internal repairs completed by an authorized service technician.
Trouble | Cause | Repair |
|
|
|
Gun leaks from fluid tip | Foreign substance between the fluid tip | Clean fluid needle in thinner |
| and needle preventing a good seal | or replace nozzle set |
|
|
|
Spray pattern | Air circuit clogged | Soak in thinner and clean the |
sickle shaped |
| nozzle set and internal needle |
|
|
|
Spray pattern | Dirt on fluid pin tip or air outlet | Turn the air nozzle 180°, clean |
oval shaped |
| fluid tip pin and air circuit |
|
|
|
Spray pattern flutters | Not enough material in the cup, | Refill material, tighten parts, |
| fluid nozzle not tight, needle sealing | clean or replace parts |
| damaged, nozzle set dirty or damaged |
|
|
|
|
Material bubbles or boils | Too much air flowing through the paint | Clean, tighten, or replace |
in the paint cup | channel to the cup, loose paint nozzle, | parts |
| loose air nozzle, clogged filter, defective |
|
| gasket, or damaged nozzle insert |
|
|
|
|
Note: To clean, change, or replace the Fluid Nozzle | FIGURE 2 |
(2), use the Wrench (35) FIGURE 2, to the |
|
right. |
|
Maintenance
Disconnect from the air source.
1.Remove the Lid (29).
2.Pour residual paint into the paint container and seal it.
3.Pour
4.Secure the Lid (29) to the Cup (28) and shake the liquid in the cup.
5.Connect to the air source and turn on the air compressor.
6.Spray the liquid onto a piece of scrap material until the spray material is free of paint.
7.Repeat if necessary.
8.Remove the entire Cup (28) by
(8). If it is not clean, use the Brush (33) to clean it. Replace the Filter (27) and thread on the Cup (28). See FIGURE 3 on page 8.
9.Use the Brush (33) to clean the recessed, hard to reach areas of the Gun.
SKU 91009 | Page 7 |