Operation
1/4” NPS
Sprayer
For best service you should incorporate an oiler, regulator, and inline filter, as shown in the diagram above. Hoses, couplers, oilers, regulators, and filters are all available at Harbor Freight Tools.
1.You will need to prepare a 1/4” air connector (sold separately) to connect to the air inlet on either the Gravity Feed or
Connect the 3/8” ID Air Source Hose to the Spray Gun.
2.Set the air pressure on your compressor to 50 PSI. Do not exceed the maximum air pressure of 50 PSI.
3.Check the air connection for leaks and then disconnect the tool from the air source.
| Gravity Feed Sprayer |
|
Trigger (5b)
Air Inlet (14b)
Air Regulator (3b)
| Adjusting Screw (17b) | ||
Air Nozzle (1b) |
|
| Spray Pattern |
|
| Adjust Knob (4a) | |
|
|
| |
| Cup (2) |
| Fluid Adjust |
|
| ||
|
|
| |
|
|
| Knob (11a) |
|
|
| Air Adjust |
|
|
| Valve (17a) |
Plastic Cup (6)
Trigger (20a)
Air Inlet (19a)
SKU 90985 | Page 5 |