Harbor Freight Tools 93205 operating instructions For technical questions, please call

Page 4

7.Use eye and ear protection. Always wear ANSI approved impact safety goggles.

Always wear an ANSI approved dust mask or respirator when using this Spray Gun.

8.Do not overreach. Keep proper footing and balance at all times. Do not reach over or across running machines or air hoses.

9.Maintain tools with care. Keep tools clean for better and safer performance. Follow instructions for lubricating and changing accessories. Inspect tool cords and air hoses periodically and, if damaged, have them repaired by an authorized technician. The handle must be kept clean, dry, and free from oil and grease at all times.

10.Disconnect air supply. Disconnect air hose when not in use, when changing accessories, and during maintenance.

11.Remove adjusting wrenches. Check that adjusting wrenches are removed from the tool before attaching to the air source.

12.Avoid unintentional starting. Be sure the trigger is in the Off position when not in use and before attaching to the air source. Do not carry any tool with your finger on the trigger, whether it is attached to the air compressor or not.

13.Stay alert. Watch what you are doing, use common sense. Do not operate any tool when you are tired.

14.Check for damaged parts. Before using any tool, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified technician. Do not use the tool if the trigger does not operate properly.

15.Replacement parts and accessories. When servicing, use only identical replacement parts. Use of any other parts will void the warranty. Only use accessories intended for use with this tool. Approved accessories are available from Harbor Freight Tools.

16.Do not operate tool if under the influence of alcohol or drugs. Read warning labels if taking prescription medicine to determine if your judgement or reflexes are impaired while taking drugs. If there is any doubt, do not operate the tool.

17.Use proper size and type extension cord. If an extension cord is required for the compressor, it must be of the proper size and type to supply the correct current to the compressor without heating up. Otherwise, the extension cord could melt and catch fire, or cause electrical damage to the compressor. Check your compressor’s manual for the appropriate size cord.

18.Maintenance. For your safety, maintenance should be performed regularly by a qualified technician and the unit must be thoroughly cleaned out after every use. Improper cleaning of the Spray Gun is a common reason for the Spray Gun to jam or not perform properly.

Page 4

For technical questions, please call 1-800-444-3353;

SKU 93205

Troubleshooting section at end of manual.

 

 

Image 4
Contents For technical questions and replacement parts, please call 93205Contents Read all instructions before using this tool Safety Warnings and PrecautionsSave This Manual For technical questions, please call For technical questions, please call Air Connection Comparison Conventional versus Hvlp Spray Guns General tips for PreparationPattern Adjustment Fan Direction and Pattern AdjustmentFan Direction Too Coarse Correct Too Fine Tighten Loosen Techniques After each use SKU For technical questions, please callPlease Read the Following Carefully Assembly Diagram Problem Spray Pattern DiagnosisProblem Cause Solution Sputtering Spray