may still remain in the Spray Gun. Point the Gun into the spent solvent container and squeeze the Trigger
(6) again to make sure no air re- mains.
•Remove the Top Cover (22) and soak it in solvent/water until it is clean. Use an old toothbrush and toothpicks to remove any remaining paint/fluid. Do not use metal ob- jects to clean the Top Cover or you may damage the drilled passages. Inspect the Fluid Needle (16) and make sure it is not bent. If it is bent, have it replaced by a qualified ser- vice technician.
•WARNING! Do not immerse the Spray Gun Body in solvent.
•Use the appropriate solvent (or wa- ter if
•Always lubricate the Spray Gun after cleaning. You may use a
5.DISPOSAL: After cleaning the Paint Sprayer and its accessories, properly dispose of your cleaning solutions ac- cording to the solution manufacturer’s direction and local hazardous waste authority instructions.
6.
WARNING! If the Power Cord (34) of this Paint Sprayer is dam- aged, it must be replaced only by a qualified service technician.
PLEASE READ THE
FOLLOWING CAREFULLY
The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation
or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/ or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.
SKU 97750 | For technical questions, please call | Page 12 |