Grizzly H8203 owner manual Maintenance, Schedule, Drill Sharpening Accessories, Cleaning

Page 21

SECTION 5: MAINTENANCE

Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious person- al injury.

Schedule

For optimum performance from your machine, follow this maintenance schedule and refer to any specific instructions given in this section.

Daily/Weekly Check:

•Clean chips from grinding/trimming areas and inside grinding wheel cover.

•Any other unsafe condition.

Monthly Check:

•Worn or damaged grinding wheel.

•Loose fan.

Drill Sharpening

Accessories

The following accessories are available for the Model H8203:

T20238—CBN Grinding Wheel

Sharpens HSS, Tin-coated, and cobalt bits.

T20239—SDC Grinding Wheel

Sharpens carbide bits.

H8203 Professional Drill Sharpening Machine

Cleaning

Cleaning the Model H8203 is relatively easy. Use a vacuum or brush to remove excess metal chips from around the grinding and trimming areas and inside the grinding wheel cover. Use the included cleaning brush (Figure 27) to clean the front grinding and rear trimming shafts. Use a cloth to remove remaining dust.

Figure 27. Cleaning rear trimming area.

Changing Grinding

Wheel

A CBN 170 grinding wheel for sharpening HSS, TiN-coated, and cobalt bits is preinstalled in the H8203. Replace this grinding wheel when it no longer sharpens drill bits to your satisfaction. How often you will need to replace the grinding wheel depends upon how often you use the machine. You can also install the optional SDC 170 grinding wheel, which sharpens carbide steel bits.

-19-

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Model H8203 Professional Drill Sharpening Machine Page Table of Contents Introduction ForewordContact Info H8203 Professional Drill Sharpening Machine H8203 Professional Drill Sharpening Machine Identification Top view of standard drill bit parts Drill Bit AnatomySafety Instructions for Machinery H8203 Professional Drill Sharpening Machine Additional Safety for Drill Sharpening Machines 110V Operation Circuit RequirementsSetup Safety SetupUnpacking InventorySite Considerations Test RunTo test run the machine Operation Safety Overview OperationsBasic Controls Calibrating Drill Bit To calibrate the drill bitMetric Size Fractional Collet No Inch Size Cutting edge parallel to collet holder Notch Setting Point Angle To adjust the point angleFront Grinding Area Rear Trimming Area Repeat Steps 3To add back relief to a standard bit To create a split point bit Drill Sharpening Accessories MaintenanceCleaning ScheduleTo replace the grinding wheel Disconnect the Sharpener from PowerTroubleshooting ServicePossible Cause Possible Solution Wiring Diagram Parts Breakdown Description Parts ListPage Page Page Warranty and Returns
Top Page Image Contents