Power tool use and care

•Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed.

•Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.

•Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.

•Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands

of untrained users.

•Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.

•Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.

•Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended could result in a hazardous situation.

Service

•Have your power tool serviced by a qualified repair personnel using only identical replacement parts. This will ensure that the safety of the power tool is maintained.

Additional safety rules for drills

•Wear ear protectors with impact drills. Exposure to noise can cause hearing loss.

•Use auxiliary handles supplied with the tool. Loss of control can cause personal injury.

•If possible, always use clamps or a vice to hold your work.

•Always switch off before you put the drill down.

•Ensure that the lighting is adequate.

•Do not put pressure on the drill, such that it slows the motor down. Allow the drill bit to cut without pressure. You will get better results and you will be taking better care of your tool.

•Keep the area free of tripping hazards.

•Do not let anyone under 18 years operate this tool.

•Only use accessory bits in good condition.

•Before drilling, check that there is sufficient clearance for the drill bit under the workpiece.

•Do not touch the bit after operation. It will be very hot.

•Keep your hands away from under the workpiece.

•Never use your hands to remove sawdust, chips or waste close by the bit.

•Rags, cloths, cord, string and the like should never be left around the work area.

•Support the work properly.

•If you are interrupted when operating the drill, complete the process and switch off before looking up.