Turning on and off
1.To start the drill press insert the switch disabling insert and move the switch up to the ‘ON’ position.
2.Move the switch down to the ‘OFF’ position to turn the drill press off.
3.Remove the switch disabling insert to prevent unauthorised use and store it in a secure location out of reach of children.
Turning on the REDEYE® laser line generator
1.The REDEYE® laser line generator emits two intense narrow beams of pure red light that intersect at the drilling point.
2.The intersection is clearly visible and will not be obscured by dust. It improves operator drilling vision, enables faster
3.To turn the laser line on move the switch to the ‘I’ position.
4.To turn off the laser line move the switch to the ‘O’ position.
Adjusting the laser
1.Clamp a scrap piece of material to the table.
2.Insert a drill bit into the chuck jaws.
3.Turn on the drill press.
4.Using the feed wheel lower the spindle and make a small mark in the workpiece.
5.Turn on the laser line generator.
6.If the laser is not aligned with the mark in the work piece, adjust as follows.
7.Using the 3mm hex key loosen the set screw that secures the laser light assembly.
8.Rotate the laser beam until it intersects the mark in the workpiece.
9.Repeat the process for the other side.
Operation
Caution. Always ensure that the drill press is switched off and the plug is removed from the power point before making any adjustments.
Caution. For through drilling always ensure that the hole in the centre of the table is aligned with the drill bit.
Warning. On
Warning. Don’t force the drill, allow the drill bit to do the work.
1. Adjust the table height, table angle, drilling depth and
14