Specifications
SAFETY
Electrical Rating | 120V~ / 60Hz / 2.4A |
|
|
|
|
Spindle Speeds | 760, 1150, 1630, 2180, 3070 RPM |
|
5 Speeds |
| |
|
| |
Table Tilt | 45º left and right |
|
Swing | 8" |
|
Spindle Stroke | 2" | 227541 |
Spindle Taper | B16 |
|
Chuck Capacity | 1/16″ - 1/2″ (13mm) |
|
Worklight Bulb Size | E14 base, 120V, 15W |
|
SETUP
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
OPERATION
Mounting
Secure the tool to a supporting structure before use. | Verify that installation surface has no hidden |
Before assembly, bolt the Base to a flat, level, | utility lines before drilling or driving screws. |
solid workbench capable of supporting the |
|
weight of the drill press and any workpieces. |
|
Assembly
Column to Base
MAINTENANCE
1.Place Column (8) on the Base (1) and align holes in the Column with holes in the Base.
2.Attach using Bolt (5), Spring Washer (4), and Washer (3) in each hole through the Column and into the Base.
Column (8)
Bolt (5)
Base (1)
Figure A: Column to Base Connection
Page 6 | For technical questions, please call | Item 60238 |