STARTING AND STOPPING
Before starting
WARNING! Note the following before
!starting:
The machine should be connected to an earthed outlet socket.
Check that the mains voltage corresponds with that stated on the rating plate on the machine.
Ensure you stand firmly. Keep people and animals well away from the working area.
Make sure that:
•Power switch, cord and electrical outlet are intact. If not, they must be replaced by an authorised repairman.
•Cooling air vents are not blocked.
•The machine and its equipment are correctly installed.
•The stand is properly fixed and that the drill is properly mounted on the stand.
•The drill is secured properly.
•Water cooling is undamaged and connected to the machine.
•Use suitable drill bits depending on whether water or dry drilling is being performed. In the event of uncertainty contact your dealer, your service workshop or an experienced operator.
•Prevent unintentional starting. Ensure the switch is in the
Starting
IMPORTANT! Changing gear may only be done when the machine is switched off. Otherwise there is a risk of damaging the gearbox.
1Set the working speed by turning the drill spindle and at the same time move the gear knob to the required position.
2Turn on the water cooling.
3Start the machine by switching on the
Also press, if desired, the SmartstartTM button.
Stopping
WARNING! The drill bit continues to rotate
!for a while after the motor has been switched off.
Do not stop the drill bit with your hands. Personal injuries can occur.
Switch the
Cooling
Run the machine unloaded for a minute or two to cool the motor.
10 – English