Husqvarna 1152417-30, DM 340 manual What is WHAT?, What is what on the drilling machine?

Page 5

WHAT IS WHAT?

1	Drill spindle	10	Inspection cover
2	Gearbox and motor module	11	Leakage hole
3	Carrying handle	12	Inspection hatch
4	Gear knob	13	Junction coupling (accessory)
5	Quick mount, for Husqvarna stand	14	Adapter (accessory)
6	Water connector	15	Ground fault circuit interrupter (not for GB)
7	LEDs for indicating power output	16	Open-ended spanner, 32 mm
8	Switch	17	Engine mount, stand
9	SmartstartTM	18	Operator′s manual

English – 5

Image 5

Contents Operator’s manual Symbols in the operator’s manual KEY to SymbolsSymbols on the machine Contents Presentation What is what on the drilling machine? What is WHAT?Steps before using a new drilling machine Safety InstructionsPersonal protective equipment Always use common senseWork area safety General safety precautionsElectrical safety Personal safetyGeneral working instructions Switch Machine′s safety equipmentBefore starting Starting and StoppingStarting StoppingMaintenance Replacing the carbon brushes Daily maintenanceReplacing the seal retainer RepairsTechnical Data Applies to Europe only EC-declaration of conformityWiring Diagram 1152417-30 ´z+TIi¶0G¨ ´z+TIi¶0G¨