Specifications
Electrical Input | 120 V~, 60 Hz, 1/3 HP (3.6 A) |
Motor Speed | 1750 RPM (No Load) |
Spindle Speeds | 620, 1100, 1720, 2340, and 3100 RPM |
Spindle Stroke | 2” |
Base | |
Throat Depth | 4” (of 8” swing) |
Chuck | 1/2”, keyless |
Table Rotation | 360°; Tilt: 45° (left and right) |
Table Size | |
Table Slot | 5/8” |
| E105017 |
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
Assembly hardware is located in separate bags/boxes. Each contains the necessary parts for each assembly step. Remove all packing and protective material from the Drill Press components.
Instructions for putting
into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly/Mounting
Note: Assembly hardware is located in separate bags/boxes.
1.Position the Base (C4) on a level and sturdy table for mounting.
It is recommended to bolt the Base to the table using appropriate hardware (not supplied).
2.Place the Support Tube (C3) on the Base, aligning the mounting holes.
3.Insert three large Hex Screws (C5) into the mounting holes and tighten.
4.Install the Table Support (C1), with attached Table (C7), over the Support Tube (C3) and slide it down. Hand tighten the Lock Handle Support (C2).
CAUTION! Avoid injuries. The next step involves lifting the Head Assembly onto the Support Tube. The Head Assembly is heavy. Have someone help you lift this assembly into place.
Guard (A5) | Knob | |
| ||
Motor | (A2) | |
| ||
Adjusting |
| |
Knob (10) |
| |
Feed | Set | |
Screws | ||
Knob (12) | ||
(11) | ||
|
5.Using two people, lift the Head (1) Assembly up and onto the Support Tube (C3).
Slide it down on the Column Tube as far as it will go. Align it so that it faces straight forward, inline with the Base.
Page 8 | For technical questions, please call | SKU 44505 |