Hilti TE 7-C operating instructions Disposal, Manufacturer’s warranty tools

Page 15

en

Fault

Possible cause

Remedy

 

 

 

The power tool doesn’t

The extension cord’s conductor

Use an extension cord with an ad-

achieve full power.

cross section is inadequate.

equate conductor cross section.

 

 

(Please refer to the “Description”

 

 

section.)

 

The control switch is not pressed

Press the control switch as far as it

 

fully.

will go.

The drill bit doesn’t rotate.

The function selector switch is not

When the motor has stopped, turn

 

engaged or is in the “Chiseling” or

the function control switch to the

 

“Chisel adjustment” position.

“Drilling without hammering” or

 

 

“Hammer drilling” position.

The drill bit can’t be released.

The chuck is not pulled back fully.

Pull the chuck back as far as it will

 

 

go and remove the insert tool.

The drill bit makes no pro-

The forward/reverse switch is set

Set the forward/reverse switch to

gress.

to reverse rotation.

forward rotation.

 

 

 

10. Disposal

Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back your old power tools or appliances for recycling. Please ask your Hilti customer service department or Hilti representative for further information.

11. Manufacturer’s warranty - tools

Hilti warrants that the tool supplied is free of defects in material and workmanship. This warranty is valid so long as the tool is operated and handled correctly, cleaned and serviced properly and in accordance with the Hilti Operating Instructions, and the technical system is maintained. This means that only original Hilti consumables, components and spare parts may be used in the tool.

This warranty provides the free-of-charge repair or replacement of defective parts only over the entire lifespan of the tool. Parts requiring repair or replace- ment as a result of normal wear and tear are not covered by this warranty.

Additional claims are excluded, unless stringent na- tional rules prohibit such exclusion. In particular, Hilti is not obligated for direct, indirect, incidental or consequential damages, losses or expenses in connection with, or by reason of, the use of, or inability to use the tool for any purpose. Implied warranties of merchantability or fitness for a par- ticular purpose are specifically excluded.

For repair or replacement, send the tool or related parts immediately upon discovery of the defect to the address of the local Hilti marketing organization provided.

This constitutes Hilti’s entire obligation with regard to warranty and supersedes all prior or contempor- aneous comments and oral or written agreements concerning warranties.

12

Image 15
Contents TE 7-C ThisProductis Listed Page Operating controls and parts ContentsSafety notices and their meaning General informationObligation signs SymbolsLocation of identification data on the power tool DescriptionGrips SwitchesUsing extension cords ChucksUsing a generator or transformer Insert tools, accessoriesTechnical data Using extension cords outdoorsGeneral Power Tool Safety Warnings Safety instructionsPower tool TE 7‑C Other information about the power toolAdditional safety precautions Personal safety Personal safetyPower tool use and care ServiceChildren must be instructed not to play with the power tool Operation Before useRemoving the chuck Working at low temperaturesFitting the insert tool Removing the insert toolCare and maintenance Fault Possible cause Remedy TroubleshootingCleaning or replacing the dust shield Checking the power tool after care and maintenanceDisposal Manufacturer’s warranty tools202931