Maintenance & Part Replacement, Disposal

MAINTENANCE & PART REPLACEMENT

Regular inspection and cleaning reduces the necessity for maintenance operations and will keep your tool in good working condition. The tool bearings and gears are life-long lubricated, however it is advised to check the condition of the grease in the head every 100 hours, if necessary replace the grease. The motor must be correctly ventilated during tool operation. For this reason avoid blocking the air inlets with hands. After use disconnect the tool from the power supply and clean carefully, use compressed air through ventilation slots.

DISPOSAL

At the end of the machine’s working life, or when it can no longer be repaired, ensure that it is disposed of according to the standard regulations of the country in which it is being used, and that the disposal operation is carried out by specialized personnel following authorized guidelines.

In all circumstances:

-Do not abandon in the environment;

-Do not dispose of together with solid urban waste products;

-Contact the special recycling centres.

WARNING

Disconnect the plug from the power supply socket before replacing any parts.

BRUSHES

The brushes must be replaced after approx. 150- 200 working hours, or if they are less then 5-6mm in length.

WARNING

For correct tool operation always change the brushes in pairs, not separately. The use of original Draper spare parts is recommended. After having fitted new brushes allow the motor to run for at least five minutes without load for the brushes to bed.

IMPORTANT:

This operation should only be performed by an authorized person.

REPLACING THE POWER SUPPLY CABLE

Check that the power supply cable is in good condition, if not have it replaced by an authorized person.The machine is fitted with a safety clutch.

- 8 -