Warning:The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the parts listed on page 6 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Operation
Refer to FIGURE 1 below and the Assembly Drawing on page 6.
Warning! Before attaching or removing the Drill Attachment, unplug the drill (not included) from the power source. If it is a cordless drill, first remove the battery. If a pneumatic drill, disconnect it’s air supply.
1.Read and fully follow the manufacturer’s safety and operating directions for the drill (not included).
2.Open the chuck on the drill (not included), and insert the Shaft (8) securely into the chuck. Tighten the chuck securely.
3.Thread the Handle (9) into the hole on either side of the Drill Attachment.
4.To install a Drill Bit, hold the Chuck Sleeve firmly in place and turn the Chuck counterclockwise. Insert the shank of a bit (not included) all the way into the Chuck. While holding the Chuck Sleeve in place, turn the Chuck clockwise to lock the Drill Bit in place.
5.Always use both hands while using this Attachment (one hand on the Handle (9) and the other hand on the hand of the drill used with the Drill Attachment.) Operate the drill according to the manufacturer’s instructions. Be careful to avoid letting the bit get stuck, as this will cause the Drill Attachment and drill to twist, possibly causing injury.
6.After operation, unplug the drill (not included) from the power source. If it is a cordless drill, remove the battery. Then, turn the Chuck (2) counterclockwise to open the jaws of the Chuck and remove the bit.
| Chuck |
FIGURE 1 | Sleeve |
| Chuck (2) |
Jaws of Chuck (2)
Handle (9)
Shaft (8)
Maintenance
1.Before each use, clean off the Shaft (8). Make sure it has no dirt, grease, or debris clinging to it.
2.Before each use, open the jaws of the Chuck (2) following the instructions above, and remove any dirt, grease, or debris. Store it in a cool, dry location, out of reach of children.
SKU 96996 | For technical questions, please call | Page |