Care and maintenance
Switching the appliance off | Inspecting the oven seals |
GB
Disconnect your appliance from the electricity supply before carrying out any work on it.
Cleaning the appliance
!Never use steam cleaners or pressure cleaners on the appliance.
•Clean the glass part of the oven door using a sponge and a
•The stainless steel or
•The inside of the oven should ideally be cleaned after each use, while it is still lukewarm. Use hot water and detergent, then rinse well and dry with a soft cloth. Do not use abrasive products.
•The accessories can be washed like everyday crockery, and are even dishwasher safe.
•Dirt and grease should be removed from the control panel using a
•Stainless steel can be marked by hard water that has been left on the surface for a long time, or by aggressive detergents containing phosphorus. After cleaning, rinse well and dry thoroughly. Any remaining drops of water should also be dried.
Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest After- sales Service Centre. We recommend that the oven is not used until the seals have been replaced.
Replacing the oven light bulb
1.After disconnecting the oven from the electricity mains, remove the glass lid covering
the lamp socket (see figure). 2. Remove the light bulb and replace it with a similar one: voltage 230 V, wattage 25 W, cap E 14.
3.Replace the lid and reconnect the oven to the electricity supply.
Assistance
Please have the following information to hand:
•The appliance model (Mod.).
•The serial number (S/N).
This information can be found on the data plate located on the appliance and/or on the packaging.
10