The legs* provided with the appliance fit into the slots on the underside of the base of the cooker.
consumer unit to the cooker, via the switched double
pole cooker outlet, must be of an acceptable type GB and current rating as above.
!the supply cable must be positioned so that it never reaches at any point a temperature 50°C higher than the room temperature. The cable must be routed away from the rear vents.
Electrical connection
Electric cookers come without a power supply cable. The cooker is designed to operate on an electricity supply which conforms to the electrical data shown on the Rating Plate. The cooker can be connected to the mains only after removing the back panel of the cooker itself with a screwdriver.
!the following installation procedure must be carried out by a qualified electrician. The electrical installation must comply with the IEE Regulations, Building & local
1. Open the terminal board by inserting a screwdriver into the side tabs of the cover. Use the screwdriver as a lever by pushing it down to open the cover (see diagram).
2. Loosen the cable clamp screw and remove it, using a screwdriver as a lever (see figure).
3. Remove the wire contact screws 
, then fasten the wires under the screw heads, respecting the colour code: Black/Blue (N), Red/Brown (L) and Bare 
).
•Once the connections have been made, tighten all the terminal screws fully.
•Fasten the supply cable in place with the clamp and close the cover of the terminal board.
Connecting the supply cable to the mains
WARNINGS: THIS APPLIANCE MUST BE EARTHED.
!The cooker must be connected to the mains by a switched (double pole) cooker outlet correctly fused with a capacity appropriate to that shown on the cooker Rating Plate. All electrical wiring from the
HOT PARTS
Mains frequency and voltage of the electrical
section
Model | Electric section | |
|
|
|
| Voltage | Power (W) |
|
|
|
I6 EVA/UK | 240V~ 50/60 Hz | 9900 |
|
|
|
Safety Chain
! In order to prevent accidental tipping of the appliance, for example by a child clim- bing onto the oven door, the supplied safety chain MUST be installed!
The cooker is fitted with a safety chain to be fixed by means of a screw (not supplied with the cooker) to the wall behind the appliance, at the same height as the chain is attached to the appliance.
Choose the screw and the screw anchor according to the type of material of the wall behind the applian- ce. If the head of the screw has a diameter smaller than 9mm, a washer should be used. Concrete wall requires the screw of at least 8mm of diameter, and 60mm of length.
Ensure that the chain is fixed to the rear wall of the cooker and to the wall, as shown in figure, so that after installation it is tensioned and parallel to the
ground level.
3
