3.Fig. 22, illustrates the table alignment pin (B) removed. Loosen table locking bolt (D), tilt table to the desired angle and tighten bolt (D). When returning table to the level position, replace table alignment pin (B). This will automatically position the table surface at 90 degrees to the spindle.
4.A tilt scale (E) Fig. 23, is provided on the table bracket casting to indicate the degree of tilt. A witness line and zero mark (F) are also provided on the table to line up with the scale (E).
B
D
Fig. 22
E
F
Fig. 23
SPINDLE SPEEDS
Five spindle speeds of 620, 1100, 1720, 2340 and 3100 RPM are available with your drill press. The highest speed is obtained when the belt is on the largest step of the motor pulley and the smallest step of the spindle pulley, as shown in Fig. 25. Fig. 25, illustrates which step of the motor and spindle pulley the belt must be placed to obtain the five speeds available.
SPINDLEMOTOR
3100
2340
1720
1100
620
Fig. 25
10