Delta 900585 instruction manual Cleaning, Assembling the Drill Press

Page 5

CLEANING

Remove the protective coating from the machined surfaces of the drill press and all loose items. This coating may be removed with a soft cloth moistened with kerosene. DO NOT use acetone, gasoline, or lacquer thinner for this purpose.

ASSEMBLING THE DRILL PRESS

1.Assemble the column (A) Fig. 4, to drill press base

(B) as shown, using the three M8 x 20mm hex head cap screws (C).

2.Assemble the table (D) Fig. 5, to drill press column

(A) as shown.

A

BC

C

Fig. 4

A

D

3.Thread clamp handle (E) Fig. 6, into holes in rear of table bracket as shown. Align table (D) to base (B) and tighten clamp handle (E).

Fig. 5

D

E

B

Fig. 6

5

Image 5
Contents Drill Press Always Wear EYE Protection Safety RulesAdditional Safety Rules For Drill Presses Unpacking Assembling the Drill Press CleaningPage Extension Cords Connecting Drill Press to Power SourceFastening Drill Press to Supporting Surface Grounding Instructions Motor SpecificationsTable Adjustments Locking Switch in the OFF PositionSpindle Speeds Changing Speeds and Adjusting Belt Tension Drilling Holes To Depth Adjusting Spindle Return SpringCorrect Drilling Speeds OperationBoring in Wood Drilling Metal